How To Remove Door Panel On 2008 Chevy Silverado

How to Remove the Door Panels on a Chevy Silverado

by Jody L. Campbell

Ablestock.com/AbleStock.com/Getty Images

Several different reasons exist for removing a door panel on a Chevy Silverado. Side window repair, speaker replacement, window control module, window motor, upgrading to a directional side-view mirror (one that displays the directional lite on the mirror when you turn on the directional switch) or even replacing the door panel itself are all reasons that require removing the door panel. The procedure is not overly complicated, but there are a few precautions to take into consideration.

Step 1

Open the door and power the window all the mode down if possible. (If yous're replacing the window motor and the window does not work, it's non required that yous have the window down, but it gives y'all more room to work with without the risk of scratching the window.)

Step ii

Remove the side view mirror sheet located in the upper corner of the door panel. This trim piece covers the interior side of the side view mirror. Pry it off with the small, angled trim tool from the top and rear side. In one case the ii retaining caps are released, pin the height of the sheet out and extract it from the bottom anchor on the door frame.

Step iii

Pry the door lock trim bezel from the rear toward the front of the door using the trim tool. Push it frontwards once the rear retaining prune is released to remove information technology from the door console.

Step iv

Utilise the trim pry tool to pry the window command module up abroad from the forepart of the arm residue. Exist aware information technology has wire harness connections beneath information technology.

Step v

Disconnect the wire harness connections. The have specific plug connections so you don't have to worry about mixing them up for reassembly. Use a small, bladed, direct-edge screwdriver to depress the plug locks, and then pull the plug connexion from the window control module. The three plug connections include the power mirror, window motor and power lock harnesses.

Stride 6

Locate and remove the door panel retaining screw underneath the rear of the window command module cavity. Utilize a 7-mm socket wrench, or a ratchet, extension and 7-mm socket.

Step 7

Remove the retaining screw beneath the door pull handle with the socket wrench or ratchet.

Pace 8

Pry the door handle trim bezel, once more from the rear toward the front of the door similar the door lock trim bezel. Unseat the door handle trim bezel and work information technology off of the door handle.

Step 9

Pry the interior door light lens from the lower rear portion of the door panel. Pry it from the bottom to unseat the clips, and so unplug the wire harness connection.

Footstep ten

Pry the door panel from the door frame with the trim tool. Showtime at the bottom and work your mode upwardly both sides.

Step 11

Lift the door console upwardly one time unseated from the door frame to remove the upper retaining lip of the panel from the door frame. Again, be enlightened that ane or two more wire harness connections will even so exist connected to the backside of the panel.

Reach behind the door panel while supporting it and disconnect the speaker wire harness and, if applicable, the heated seat wire harness. Remove the door panel.

References

Things You'll Need

• Small, angled trim pry tool
• Small, bladed directly-edge screwdriver
• 7-mm socket wrench or ratchet with a pocket-sized extension and 7-mm socket

Writer Bio

Jody Fifty. Campbell spent over 15 years every bit both a manager and an under-car specialist in the automotive repair industry. Prior to that, he managed 2 dissimilar restaurants for over 15 years. Campbell began his professional writing career in 2004 with the publication of his first book.

More Articles

Source: https://itstillruns.com/remove-door-panels-chevy-silverado-5887497.html

Share this post